BYD Seal Underbody Aero Shield Inspection, Jacking Puck Points & Tyre Rotation Guide
-
@Duncan_Seal Where did you grab your rubber jacking pucks? I keep a set of 4 in the frunk so any tyre shop has no excuse when lifting the car.
@Henry_H_TangEV The flat underbody aero trays on the Seal are super clean—not a single loose clip after driving through heavy winter rain.
-
@Henry_H_TangEV The flat underbody aero trays on the Seal are super clean—not a single loose clip after driving through heavy winter rain.
@nicola_h Thanks for posting the exact numbers—bookmarked this thread for my upcoming service.
-
@nicola_h Thanks for posting the exact numbers—bookmarked this thread for my upcoming service.
@Andrew_NovatedAU Totally agree. Once you dial in the tyre pressures and regen settings, it transforms the daily drive.
-
@Andrew_NovatedAU Totally agree. Once you dial in the tyre pressures and regen settings, it transforms the daily drive.
@lukas_v_at Has anyone else noticed slightly better efficiency after the latest BMS calibration? Mine dropped by ~0.4 kWh/100km.
-
Interesting point about the charging curve. I found that plugging in around 15–18% SOC gives the fastest sustained peak kW before the BMS gently tapers above 80%.
-
For anyone reading this later: make sure you enable SOC calibration by charging to 100% on AC at least once every two to three weeks so the BMS range estimator stays dead accurate.
-
Subscribed to this thread. Has anyone here compared this behaviour before and after the latest DiLink OTA firmware update? Mine felt noticeably smoother in low-speed traffic afterwards.
-
Checked this with my dealer's senior HV technician at my scheduled service—everything lines up with the latest BYD global technical bulletin.
-
-
Great write-up! If anyone is on the fence, definitely take a 45-minute test drive on coarse-chip highway tarmac first — the acoustic glass makes a bigger difference than the spec sheet suggests.
-
Spot on breakdown. One detail I noticed after logging another 2,500 km is that the thermal management loop stays completely silent below 32°C ambient unless you chain two fast DC sessions back-to-back.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login